|
DTC Advanced Diagnostics: B0097-87
DTC B0097-87: No Signal From the Right Side Impact Sensor (second)
NOTE
|
|
Always check "How to troubleshoot the SRS system" and proceed along each "DTC Troubleshooting" procedure. |
|
|
Make sure the 12 volt battery is fully charged. If not, the results of tests may not be accurate. |
|
|
The SRS indicator will turn on when the 12 volt battery voltage becomes below 10 volts. |
|
|
The possible causes shown may not be a complete list of all potential problems, and it is possible that there may be other causes. |
|
Confirmation Procedure |
Basic Condition:
|
|
12 volt battery voltage 10 - 16 V |
Operating Condition:
|
1. |
Turn the vehicle to the ON mode, and wait 6 seconds. | |
|
Duration |
About 6 seconds |
|
DTC Type |
|
|
1 drive cycle |
|
|
SRS indicator on | |
|
Fail Safe Action |
|
|
Possible Cause |
|
|
Open, Short to another line, Short to ground, Short to power, or Poor connection between the SRS unit and the right side impact sensor (second) (RS2+, RS2- lines) |
|
|
Right side impact sensor (second) internal failure |
|
|
SRS unit internal failure | | |
| | 
