|
DTC Advanced Diagnostics: B00C0-87
DTC B00C0-87: No Signal From the Front Passenger's Weight Sensor (front inner side)
NOTE
|
|
Always check "How to troubleshoot the SRS system" and proceed along each "DTC Troubleshooting" procedure. |
|
|
Make sure the 12 volt battery is fully charged. If not, the results of tests may not be accurate. |
|
|
The SRS indicator will turn on when the 12 volt battery voltage becomes below 10 volts. |
|
|
The possible causes shown may not be a complete list of all potential problems, and it is possible that there may be other causes. |
|
Confirmation Procedure |
Basic Condition:
|
|
Battery voltage 10 - 16 V |
Operating Condition:
|
1. |
Turn the vehicle to the ON mode, and wait 6 seconds. | |
|
Duration |
About 6 seconds |
|
DTC Type |
|
|
1 drive cycle |
|
|
SRS indicator on | |
|
Fail Safe Action |
|
|
Possible Cause |
|
|
Open or poor connection between the SRS unit and the front passenger's weight sensor (front inner side) (SWS+, SWSS, SWS- lines) |
|
|
Short to power or short to ground between the SRS unit and the front passenger's weight sensor (front inner side) (SWSS line) |
|
|
Short to another line or poor connection between the SRS unit and the front passenger's weight sensor (front inner side) (SWSS to SWS+ lines, SWSS to SWS- lines) |
|
|
SRS unit internal failure |
|
|
Front passenger's weight sensor internal failure (front inner side) | | |
| | 
