|
DTC Advanced Diagnostics: C0063-96
DTC C0063-96: Yaw-Rate Sensor Malfunction
NOTE
|
|
Initial Diagnosis:
The initial on-board diagnosis occurs right after the vehicle condition is turned to the ON mode, and the EPS indicator comes on, and continues until the indicator goes off. |
|
|
Regular Diagnosis:
The regular on-board diagnosis begins right after the EPS indicator goes off, and it continues until the vehicle condition is turned to the OFF (LOCK) mode. |
|
|
Review "How to troubleshoot the EPS system" before doing the DTC troubleshooting procedure. |
|
|
Test-drive the vehicle according to local traffic conditions and regulations. Do not test-drive on a lift unless specified. |
|
|
The possible causes shown may not be a complete list of all potential problems, and it is possible that there may be other causes. |
|
Confirmation Procedure |
Basic Condition:
|
|
12 volt battery voltage 10 - 16 V |
|
|
IG voltage continued more than 10 V for at least 1 second |
With the Driving Pattern:
|
1. |
Turn the vehicle to the ON mode. |
|
2. |
Wait 30 seconds or more. | |
|
Execution |
Regular Diagnosis |
|
Duration |
About 30 seconds |
|
DTC Type |
|
|
1 drive cycle |
|
|
EPS indicator on | |
|
Fail Safe Action |
|
|
Continue EPS function/assist |
|
|
Stop motion adaptive-EPS function/assist | |
|
Possible Cause |
|
|
SRS unit internal failure | | |
| | 
