DTC Advanced Diagnostics: C0019-49

DTC C0019-49: Outlet Solenoid (Left Rear) Circuit Failure

NOTE

	Initial Diagnosis: The initial on-board diagnosis occurs right after the vehicle condition is turned to the ON mode, and the ABS/VSA indicator comes on, and continues until the indicator goes off.
	Regular Diagnosis: The regular on-board diagnosis begins right after the ABS/VSA indicator goes off, and it continues until the vehicle condition is turned to the OFF (LOCK) mode.
	Review "How to troubleshoot the VSA system" before doing the DTC troubleshooting procedure.
	Test-drive the vehicle according to local traffic conditions and regulations. Do not test-drive on a lift unless specified.
	The possible causes shown may not be a complete list of all potential problems, and it is possible that there may be other causes.

Confirmation Procedure

Basic Condition:

	12 volt battery voltage 9.6 - 16.5 V
	ABS/VSA function not in operation

With the Driving Pattern:

1.	Start the engine.
2.	Wait 20 seconds or more.

Execution

Initial Diagnosis/Regular Diagnosis

Duration

About 20 seconds

DTC Type

	1 drive cycle
	Brake system indicator (red) on
	Brake system indicator (amber) on
	ABS indicator on
	VSA indicator on

Fail Safe Action

	Stop EBD function
	Stop ABS function
	Stop engine drag torque control function
	Stop TCS function
	Stop VSA function
	Stop agile handling assist function
	Stop brake assist function
	Stop hydraulic boost failure compensation function
	Stop hill start assist function
	Stop automatic brake hold function
	Stop automatic operating function (Drive away assist)
	Stop ignition OFF apply function
	Stop ACC function*
	Stop CMBS function*

Possible Cause

VSA modulator-control unit internal failure

*: With ACC