Confirmation Procedure |
Basic Condition:
|
12 volt battery voltage 9.6 - 16.5 V |
With the Driving Pattern:
1. |
Start the engine. |
2. |
Test-drive the vehicle for 80 seconds or more.
(Be careful of the surrounding traffic conditions.) | |
Execution |
Regular Diagnosis |
Duration |
About 80 seconds |
DTC Type |
|
1 drive cycle |
|
Brake system indicator (red) on (If multiple wheel failures are detected) |
|
Brake system indicator (amber) on |
|
ABS indicator on |
|
VSA indicator on | |
Fail Safe Action |
|
Stop EBD function (If multiple wheel failures are detected) |
|
Stop ABS function |
|
Stop engine drag torque control function |
|
Stop TCS function |
|
Stop VSA function |
|
Stop agile handling assist function |
|
Stop brake assist function |
|
Stop hydraulic boost failure compensation function |
|
Stop hill start assist function |
|
Stop automatic brake hold function |
|
Stop automatic operating function (Drive away assist) |
|
Stop automatic operating function (Request from other system) (Dependant upon the conditions) |
|
Stop ignition OFF apply function |
|
Stop ACC function* |
|
Stop CMBS function* | |
Possible Cause |
|
Electrical noise in the right- front wheel speed sensor signal |
|
Right-front wheel speed sensor incorrect installation |
|
Debris on the right-front encoder surface |
|
Right-front wheel speed sensor failure |
|
VSA modulator-control unit internal failure | |