|
DTC Advanced Diagnostics: U3003-17
DTC U3003-17: Electric Parking Brake Control Unit Power Source Circuit (+B) High Voltage
NOTE
|
|
Initial Diagnosis:
The initial on-board diagnosis occurs right after the vehicle condition is turned to the ON mode, and the ABS/VSA indicator comes on, and continues until the indicator goes off. |
|
|
Regular Diagnosis:
The regular on-board diagnosis begins right after the ABS/VSA indicator goes off, and it continues until the vehicle condition is turned to the OFF (LOCK) mode. |
|
|
Review "How to troubleshoot the VSA system" before doing the DTC troubleshooting procedure. |
|
|
Test-drive the vehicle according to local traffic conditions and regulations. Do not test-drive on a lift unless specified. |
|
|
The possible causes shown may not be a complete list of all potential problems, and it is possible that there may be other causes. |
|
Confirmation Procedure |
With the Driving Pattern:
|
|
Execution |
Regular Diagnosis |
|
Duration |
About 1 second |
|
DTC Type |
|
|
1 drive cycle |
|
|
Brake system indicator (amber) on | |
|
Fail Safe Action |
|
|
Stop automatic brake hold function |
|
|
Stop manual operating function |
|
|
Stop automatic operating function (Drive away assist) |
|
|
Stop automatic operating function (Request from other system) |
|
|
Stop ignition OFF apply function |
|
|
Stop ACC function* |
|
|
Stop CMBS function* | |
|
Possible Cause |
|
|
PGM-FI system failure |
|
|
Abnormal 12 volt battery |
|
|
VSA modulator-control unit internal failure | | |
|
| | 
