DTC Advanced Diagnostics: P05A3, P05B2

DTC P05A3:Shutter Grille Actuator (Upper) Malfunction
DTC P05B2:Shutter Grille Actuator (Lower) Malfunction

General Description

The shutter grille system open/closes the shutter depending on the driving conditions. The system improves fuel efficiency by reducing the wind drag. The shutter is controlled by the shutter grille which integrates the actuator. The powertrain control module (PCM) sends open/close requests which depends on the driving conditions to the shutter grille via the LIN line. Also the PCM receives failure information from the shutter grille via the LIN line. The PCM discriminates a failure by the signal value received via the LIN line. If the PCM receives a specified signal from the shutter grille, the PCM detects as a shutter grille LIN line open/short failure and stores a DTC.

Monitor Execution, Sequence, Duration, DTC Type

Execution	Continuous
Sequence	None
Duration	2.5 seconds or more
DTC Type	One drive cycle, MIL off

Enable Conditions

Condition
State of the engine	Running

Malfunction Threshold

Either of these conditions occurs:

	When the upper or lower actuator state of short to ground or EEPROM of the read / write errors of the motor has continued for at least 2.5 seconds or more.
	When the upper or lower actuator is the state of the transmit / receive error in LIN communication was continued at least 2.5 seconds or more.

Possible Cause

NOTE: The causes shown may not be a complete list of all potential problems, and it is possible that there may be other causes.

DTC: P05A3

	Upper shutter grille LIN line open
	Upper shutter grille LIN line short to ground
	Upper shutter grille LIN line short to power

DTC: P05B2

	Lower shutter grille LIN line open
	Lower shutter grille LIN line short to ground
	Lower shutter grille LIN line short to power

Common

PCM internal circuit failure

Diagnosis Details

Conditions for setting the DTC

When a malfunction is detected, the PGM-FI display comes on and a Pending DTC, a Confirmed DTC, and the freeze data are stored in the PCM memory. The MIL does not come on.

Conditions for clearing the DTC

The PGM-FI display is cleared if the malfunction does not return in three consecutive trips in which the diagnostic runs. The PGM-FI display, the Pending DTC, the Confirmed DTC, and the freeze data can be cleared with the scan tool Clear command.