DTC Advanced Diagnostics: P0101
DTC P0101:Mass Air Flow (MAF) Sensor Circuit Range/Performance Problem (Out of Range)

General Description

The mass air flow (MAF) sensor is attached to the intake air passage, and it measures the amount of intake air flow. The MAF sensor is a chip type air flow meter. The air flow cools the electrically heated chip that is mounted in the air passage. The powertrain control module (PCM) determines the amount of intake air flow by detecting the frequency. If the MAF sensor input frequency is out of range, the PCM detects a malfunction and stores a DTC.

Monitor Execution, Sequence, Duration, DTC Type
Execution
Continuous
Sequence
None
Duration
3.0 seconds or more
DTC Type
Two drive cycles, MIL on

Enable Conditions
Condition
 
Vehicle
ON mode

Malfunction Threshold
The MAF sensor input frequency [MAF SENSOR] is out of range from 520 to 10,000 Hz for at least 3.0 seconds.

[ ]: HDS Parameter

Possible Cause
NOTE: The causes shown may not be a complete list of all potential problems, and it is possible that there may be other causes.
MAF sensor failure

Diagnosis Details
Conditions for setting the DTC
When a malfunction is detected during the first drive cycle, a Pending DTC is stored in the PCM memory. If the malfunction returns in the next (second) drive cycle, the MIL comes on and a Confirmed DTC, the freeze data, and the on-board snapshot are stored.

Conditions for clearing the DTC
The MIL is cleared if the malfunction does not return in three consecutive trips in which the diagnostic runs. The MIL, the Pending DTC, the Confirmed DTC, the freeze data, and the on-board snapshot can be cleared with the scan tool Clear command or by disconnecting the 12 volt battery.