Cut the adhesive tape (B, C, D) along the edge of the door lower trim (E) with a utility knife while separating the trim from the door (F) with a trim tool.
NOTE: Apply protective tape around the cutting area.
3.
Slide the door lower trim rearward and remove it.
NOTE: The clips (G, H) will stay in the door.
4.
Remove the clips by turning.
2.
Front Door Lower Seal - Remove
1.
If necessary, remove the front door lower seal (A) with the clips and double-sided adhesive tape (B).
1.
Front Door Lower Seal - Install
1.
Install the front door lower seal (A).
NOTE: Apply adhesive primer to the areas where the new double-sided adhesive tape (B) will be applied.
2.
Front Door Lower Trim - Install
1.
If you are reusing the original door lower trim (A), apply primer to the areas where new double-sided adhesive tapes (B, C, D) will be applied, then attach the new double-sided adhesive tapes to the trim as shown.
Double-sided adhesive tape (B)
Thickness
1.0 mm (0.039 in)
Width
8 mm (0.31 in)
Length
95 mm (3.74 in)
Double-sided adhesive tape (C)
Thickness
1.2 mm (0.047 in)
Width
8 mm (0.31 in)
Length
1000 mm (39.37 in)
Double-sided adhesive tape (D)
Thickness
1.0 mm (0.039 in)
Width
6 mm (0.24 in)
Length
50 mm (1.97 in)
2.
Install the clips (A, B) on the door lower trim (C) or door (D).
3.
Install the door lower trim.
NOTE: Scrape off the remaining double-sided adhesive tape from the door, then clean the surface with a sponge dampened in isopropyl alcohol. After cleaning, keep oil, grease, and water from getting on the surface.
4.
Install the screw and the clips (E, F) to the door lower trim.
