Cut the adhesive tape (B, C) along the edge of the door lower trim (D) with a utility knife while separating the trim from the door (E) with a trim tool.
NOTE: Apply protective tape around the cutting area.
3.
Slide the door lower trim forward and remove it.
NOTE: The clips (F, G) will stay in the door.
4.
Remove the clips by turning.
2.
Rear Door Lower Seal - Remove
1.
If necessary, remove the rear door lower seal (A) with the clips and double-sided adhesive tape (B).
1.
Rear Door Lower Seal - Install
1.
Install the rear door lower seal (A).
NOTE: Apply adhesive primer to the areas where the new double-sided adhesive tape (B) will be applied.
2.
Rear Door Lower Trim - Install
1.
If you are reusing the original door lower trim (A), apply primer to the areas where new double-sided adhesive tapes (B, C) will be applied, then attach the new double-sided adhesive tapes to the trim as shown.
Double-sided adhesive tape (B)
Thickness
1.0 mm (0.039 in)
Width
8 mm (0.31 in)
Length
85 mm (3.35 in)
Double-sided adhesive tape (C)
Thickness
1.2 mm (0.047 in)
Width
8 mm (0.31 in)
Length
600 mm (23.62 in)
2.
Install the clips (A, B) on the door lower trim (C) or door (D).
3.
Install the door lower trim.
NOTE: Scrape off the remaining double-sided adhesive tape from the door, then clean the surface with a sponge dampened in isopropyl alcohol. After cleaning, keep oil, grease, and water from getting on the surface.
4.
Install the screw and the clips (E) to the door lower trim.
