Driver's Seat Position Sensor Removal and Installation

SRS components are located in this area. Review the SRS component locations and the precautions and procedures before doing repairs or service.

NOTE:
How to read the torque specifications.
Do not turn the vehicle to the ON mode, while removing or installing the driver's seat position sensor.


NOTE: Raise the driver's seat all the way up.

2. Driver's Seat Position Sensor - Remove
1.
Disconnect the connector (A).
2.
Remove the nut (B), then remove the driver's seat position sensor (C).

3. All Removed Parts - Install
1.
Install the all removed parts in the reverse order of removal.
NOTE:
Be sure to install the harness so it is not pinched or interferes with other parts.
After replacing the driver's seat position sensor with a new one, check the driver's seat position sensor operation.

5. SRS Operation - Confirm
1.
Turn the vehicle to the ON mode, and check that the SRS indicator comes on for about 6 seconds and then goes off.