Automatic Brake Hold Switch Removal, Installation, and Test
1.
Shift Lever Panel - Remove
2.
Automatic Brake Hold Switch - Remove
3.
All Removed Parts - Install
1.
Install all removed parts in the reverse order of removal.
1.
Automatic Brake Hold Switch - Test
Electric parking brake/automatic brake hold switch 12P connector (male terminals)
1.
On the switch side, measure the resistance between the connector terminal in each switch position according to the table.
2.
If the switch does not work as described in the table, replace the switch.
Position
Resistance
PRESSED
About 559 ?
RELEASED
About 2200 ?
