Engine Oil Pan Removal and Installation

NOTE: enu_12713377_2.0 Where icon is shown, click for further information.


1


1904_3.0_enu_14741366_5.0

enu_12713377_2.0
Detailed information, notes, and precautions
enu_12714524_1.0
Replace


NOTE:
Do not disconnect the A/C hoses.
Do not bend the A/C hoses excessively.
Hang the A/C compressor with a wire tie.

6. Engine - Support
1.
Support the engine with a transmission jack and a wood block under the oil pan.

8. Torque Converter Case Cover - Remove


9. Oil Pan - Remove
1.
Remove the bolts securing the oil pan.
2.
Using a flat blade screwdriver, separate the oil pan from the lower block in the places shown.
3.
Remove the oil pan.


NOTE: enu_12713377_2.0 Where icon is shown, click for further information.


1


1904_3.0_enu_14741369_5.0

enu_12713377_2.0
Detailed information, notes, and precautions
enu_12714505_1.0
Torque: N·m (kgf·m, lbf·ft)
enu_12714524_1.0
Replace

1. Oil Pan - Install
1.
Apply liquid gasket to the engine block mating surface of the oil pan, and to the inside edge of the threaded bolt holes.
2.
Install the oil pan (A) with a new O-ring (B).
3.
Tighten the bolts in three steps; tighten the bolts until the bolts sit on the oil pan, tighten the bolts until the gasket is compressed, tighten the bolts to specified torque. Wipe off the excess liquid gasket on the each side of crankshaft pulley and drive plate.

2. Torque Converter Case Cover - Install