Transmission End Crankshaft Oil Seal Replacement - In Car (2.4 L Engine)

Transmission End Crankshaft Oil Seal Replacement - In Car

Special Tools Required

Image	Description/Tool Number
	Driver Handle, 15 x 135L 07749-0010000
	Oil Seal Driver Attachment, 96 mm 07ZAD-PNAA100

NOTE:

Where icon is shown, click for further information.

	Detailed information, notes, and precautions
	Replace

1.	Transmission - Remove

2.	Drive Plate - Remove

3.	Transmission End Crankshaft Oil Seal - Remove

4.	Transmission End Crankshaft Oil Seal - Install

Clean and dry the transmission end crankshaft oil seal housing.

Apply a light coat of new engine oil to the lip of the transmission end crankshaft oil seal.

Using the driver handle, 15 x 135L and the oil seal driver attachment, 96 mm, to drive a new transmission end crankshaft oil seal (A) squarely into the engine block to the specified installed height.

Measure the distance between the engine block (A) and the transmission end crankshaft oil seal (B).

Oil Seal Installed Height:

0.2?1.2 mm (0.008?0.047 in)

5.	All Removed Parts - Install

Install the parts in the reverse order of removal.