Water Pump Removal, Installation, and Inspection

1


1955_3.0_enu_14741530_5.0

enu_12714505_1.0
Torque: N·m (kgf·m, lbf·ft)
enu_12714524_1.0
Replace

5. Harness Holder - Move


6. Water Pump - Remove


7. All Removed Parts - Install
1.
Install the parts in the reverse order of removal.
NOTE:
Inspect and clean the O-ring groove and the mating surface of the water passage.
After installing all the removed parts, refill the radiator with engine coolant, and bleed the air from the cooling system.

2. Water Pump - Inspect
1.
Turn the water pump pulley clockwise, and check that it turns freely and smoothly. If it does not turn smoothly, replace the water pump.
NOTE: When you check the water pump, you may see a small amount of "weeping" from the bleed holes (A). This is normal.

3. All Removed Parts - Install
1.
Install the parts in the reverse order of removal.