Transmission Fluid Pump Removal and Installation

NOTE:
enu_12713377_2.0 Where icon is shown, click for further information.
Keep all foreign particles out of the transmission.


1



enu_12713377_2.0
Detailed information, notes and precautions
enu_12714524_1.0
Replace


NOTE: Make sure to reset the learned value of CVT system when replacing hydraulically-controlled parts in order not to cause any damage the transmission. The learned value of the CVT system is reset when the negative battery terminal is disconnected.

5. Transmission Fluid Pan - Remove

NOTE: The actual transmission fluid (HCF-2) capacity will vary from the specified capacity based on the length of time the transmission fluid pan is off the transmission. Avoid leaving the transmission fluid pan off for extend periods of time.

6. Magnet - Remove


7. Transmission Fluid Strainer - Remove


8. Transmission Fluid Strainer - Check
1.
Clean the inlet opening (A) of the transmission fluid strainer (B) thoroughly with compressed air.
2.
Check that it is in good condition and that the inlet opening is not clogged.
3.
Test the strainer by pouring clean transmission fluid through the inlet opening, and replace it if it is clogged or damaged.

10. 10.9 x 26 mm Pipe - Remove


11. 8 x 133.5 mm Pipe - Remove


12. 12 x 56.7 mm Pipe - Remove


13. Joint Pipe - Remove
NOTE: Be careful not to drop the filter (A).


14. 10.9 x 18.5 mm Pipe - Remove


15. 14.3 x 36.2 mm Pipe - Remove


16. 18 x 18 mm Pipe - Remove


17. Transmission Fluid Pump - Remove



NOTE:
enu_12713377_2.0 Where icon is shown, click for further information.
Keep all foreign particles out of the transmission.
Apply a light coat of clean transmission fluid on all O-rings before installation.
Be careful not to damage the O-rings.


1



enu_12713377_2.0
Detailed information, notes and precautions
enu_12714505_1.0
Torque: N·m (kgf·m, lbf·ft)
enu_12714524_1.0
Replace

1. Transmission Fluid Pump - Install
NOTE:
Apply transmission fluid to the transmission fluid pump shaft splines (A).
Align the guide pin (B) of the transmission fluid pump with the guide hole (C) of the stator shaft flange.

2. 18 x 18 mm Pipe - Install


3. 14.3 x 36.2 mm Pipe - Install

NOTE: You can install the pipe regardless of its direction.

4. 10.9 x 18.5 mm Pipe - Install


5. Joint Pipe - Install
NOTE:
The joint pipe has the filter (A). The filter end should face the valve body assembly side.
Be careful not to drop the filter.

6. 12 x 56.7 mm Pipe - Install

NOTE: You can install the pipe regardless of its direction.

7. 8 x 133.5 mm Pipe - Install


8. 10.9 x 26 mm Pipe - Install


10. Transmission Fluid Strainer - Install

NOTE: Do not pinch solenoid wire harnesses A and B.

11. Magnet - Install


12. Transmission Fluid Pan - Install

NOTE:
Tighten the transmission fluid pan mounting bolts in a crisscross pattern in at least two steps.
Do not pinch solenoid wire harnesses A and B.

17. TCM - Reset (1.5 L engine)

NOTE:
Make sure to reset the learned value of CVT system when replacing hydraulically-controlled parts in order not to cause any damage the transmission.
This procedure is not required, only for replacing transmission fluid pump.
This procedure is not required, if the transmission fluid pump and the TCM are replaced simultaneously.