Transmission Fluid Temperature Sensor Test

NOTE: Unless otherwise indicated, illustrations used in the procedure are for the model not equipped with the CVTF cooler.

3. Transmission Fluid Temperature Sensor - Test
1.
Disconnect the connector (A).
NOTE: To prevent damage, cover the connector using a shop towel.
2.
Measure the resistance between connector (male terminals) No. 6 and No. 7 (B).
Standard:
50 ??25 k?
If the resistance is within the standard, the test is complete.
If the resistance is out of the standard, replace the transmission fluid temperature sensor.

4. All Removed Parts - Install
1.
Install the parts in the reverse order of removal.
NOTE: Check the connector for corrosion, dirt, or oil, and clean or repair if necessary.