Power Mirror Actuator/Retract Actuator Removal and Installation

NOTE:

Where icon is shown, click for further information.

The power mirror actuator is a part of the power mirror assembly, and it cannot be replaced by itself.

With Side Turn Signal Light

	Detailed information, notes, and precautions
	Torque: N·m (kgf·m, lbf·ft)
	Replace

Without Side Turn Signal Light

	Detailed information, notes, and precautions
	Torque: N·m (kgf·m, lbf·ft)
	Replace

Without Side Turn Signal Light

With Side Turn Signal Light

1.	MIror Visor - Remove

2.	Connector - Disassembly

Release the lock (A) and remove the terminal (B) from the connector (C).

Note for installation

Insert the power mirror wires into the terminal locations as shown.

3.	Gasket/Harness Clip - Remove

Note for installation

Install the gasket (A) and the harness clip (B) on the wire harness at the proper positions, and apply the electrical tapes (C) and the EPDM (D) to fix them.

4.	Wire Harness - Remove

5.	Base Cover - Remove

6.	Power Mirror Actuator - Remove

7.	All Removed Parts - Install

Install the parts in the reverse order of removal.

8.	LaneWatch Camera - Aim (With LaneWatch)

Without Side Turn Signal Light

1.	Mirror Housing Cover - Remove

2.	Power Mirror - Remove

3.	Connector - Disassembly

Release the lock (A) and remove the terminal (B) from the connector (C).

4P Connector Type

14P Connector Type

Note for installation

Insert the power mirror wires into the terminal locations as shown.

4P Connector Type

14P Connector Type

4.	Gasket/Harness Clip - Remove

Note for installation

Install the gasket (A) and the harness clip (B) on the wire harness at the proper positions, and apply the electrical tapes (C) and the EPDM (D) to fix them.

5.	Wire Harness - Remove

6.	Base Cover - Remove

7.	Power Mirror Assembly - Remove

8.	Power Mirror Actuator - Remove

9.	All Removed Parts - Install

Install the parts in the reverse order of removal.