Driver's Power Tailgate Switch Removal, Installation, and Test

NOTE: The switch location of the driver's power tailgate switch is different depending on the the model.


1

3609_3.0_enu_14789921_5.0

2. Driver's Power Tailgate Switch - Remove


3. All Removed Parts - Install
1.
Install the parts in the reverse order of removal.

1. Driver's Power Tailgate Switch - Test

12P connector type


4P connector type
The switch location of the driver's power tailgate switch (A) is different depending on the the model.
1.
Check the driver's power tailgate switch for continuity and voltage according to the table.
NOTE:
Before testing, make sure not to short the driver's power tailgate switch circuit.
When an LED is located between terminals, check if the LED lights up by connecting power and ground to the LED.
Note this important operating characteristic; diode bias causes a diode to fully conduct electricity in one direction (forward), while not at all in the opposite direction (reverse).
2.
If the continuity is not as specified, replace the driver's power tailgate switch.