Power Window Motor Test
Driver's

2. Driver's Power Window Motor - Test
NOTE: Before testing, make sure not to short the power window motor circuit.
1.
Remove the harness clips from the door panel as needed.
2.
Test the motor in each direction by connecting 12 volt battery power and ground to the power window master switch connector according to the table. When the motor stops running, disconnect battery power immediately.
If the motor does not run or fails to run smoothly, remove the driver's door regulator, then go to step 3.

4.
Test the driver's power window motor (A) by connecting battery power and ground according to the table. When the motor stops running, disconnect battery power immediately.
5.
If the motor does not run or fails to run smoothly, the driver's power window motor is faulty; replace the driver's door regulator.
If the motor runs smoothly, replace the wire harnesses or adjust the driver's door glass.

3. All Removed Parts - Install
1.
Install the parts in the reverse order of removal.

Front Passenger's

2. Front Passenger's Power Window Motor - Test
NOTE: Before testing, make sure not to short the power window motor circuit.
1.
Remove the harness clips from the door panel as needed.
2.
Test the motor in each direction by connecting battery power and ground to the connector according to the table. When the motor stops running, disconnect battery power immediately.
If the motor does not run or fails to run smoothly, remove the front passenger's door regulator, then go to step 3.

4.
Test the front passenger's power window motor (A) by connecting battery power and ground according to the table. When the motor stops running, disconnect battery power immediately.
5.
If the motor does not run or fails to run smoothly, the front passenger's power window motor is faulty; replace the front passenger's door regulator.
If the motor runs smoothly, replace the wire harnesses or adjust the front passenger's door glass.

3. All Removed Parts - Install
1.
Install the parts in the reverse order of removal.

Rear

2. Rear Power Window Motor - Test
NOTE: Before testing, make sure not to short the power window motor circuit.
1.
Test the motor rear power window in each direction by connecting battery power and ground at the connector according to the table. When the motor stops running, disconnect battery power immediately.
If the motor does not run or fails to run smoothly, remove the rear door regulator, go to step 2.

3.
Test the rear power window motor (A) by connecting power and ground according to the table. When the motor stops running, disconnect battery power immediately.
4.
If the motor does not run or fails to run smoothly, the rear power window motor is faulty; replace the rear door regulator.
If the motor runs smoothly, replace the wire harnesses or adjust the rear door glass.

3. All Removed Parts - Install
1.
Install the parts in the reverse order of removal.