Wiper/Washer Switch Removal, Installation, and Test

NOTE: SRS components are located in this area. Review the SRS component locations and the precautions and procedures before doing repairs or service.


1

3647_3.0_enu_14790011_7.0

2. Wiper/Washer Switch - Remove


3. All Removed Parts - Install
1.
Install the parts in the reverse order of removal.

1. Wiper/Washer Switch - Test


Windshield

Rear window
1.
Inspect the connector terminals to be sure they are all making good contact.
If the terminals are bent, loose or corroded, repair them as necessary, and recheck the system.
If the terminals are OK, go to step 2.
2.
Check for continuity between the terminals in each switch position according to the table.
3.
If the continuity is not as specified, replace the wiper/washer switch.