Roof Console Module Removal, Installation, and Test

NOTE:

Where icon is shown, click for further information.

	Detailed information, notes, and precautions
	Torque: N·m (kgf·m, lbf·ft)
*1	Interior Light: LED Front Individual Map Light: LED Ambient Light: LED

1.	Lens - Remove

Carefully pry off the lenses.

2.	Roof Console Module - Remove

3.	All Removed Parts - Install

Install the parts in the reverse order of removal.

1.	Roof Console Module - Test

NOTE: The interior light switch and the individual map light switch are built into the roof console module (A).

Check the interior light switch and the individual map light switch according to the table.

NOTE:

When an LED is located between terminals, check if the LED lights by connecting power and ground to the LED.

Note this important operating characteristic; diode bias causes a diode to fully conduct electricity in one direction (forward), while not at all in the opposite direction (reverse).

If the result is not as specified, the interior light switch and/or the individual map light switch are faulty; replace the roof console module.