DTC Troubleshooting: P2252
DTC P2252: A/F Sensor (Sensor 1) VS Circuit Low Voltage
NOTE: Before you troubleshoot, review the general troubleshooting information.

DTC Description
Confirmed DTC
Pending DTC
P2252 A/F Sensor (Sensor 1) VS Circuit Low Voltage
    

1.
Problem verification:

Problem verification
?1.
Turn the vehicle to the ON mode.

?2.
Clear the DTC with the HDS.


?3.
Turn the vehicle to the OFF (LOCK) mode.

?4.
Start the engine.

?5.
Hold the engine speed at 3,000 rpm without load (in P or N) until the radiator fan comes on, then let it idle.

?6.
Check for Pending or Confirmed DTCs with the HDS.
DTC Description
Confirmed DTC
Pending DTC
P2252 A/F Sensor (Sensor 1) VS Circuit Low Voltage
    

Is DTC P2252 indicated?

     
YES
     
     
     
Go to step 2.
     
NO
     
     
     
Intermittent failure, the system is OK at this time. Check for poor connections or loose terminals at the A/F sensor (Sensor 1) and the PCM. If the on-board snapshot of this DTC is recorded, try to reproduce the failure under the same conditions with the on-board snapshot.?
2.
Shorted wire check (VS line):

Shorted wire check (VS line)
?1.
Turn the vehicle to the OFF (LOCK) mode.

?2.
Jump the SCS line with the HDS, and wait more than 1 minute.


?3.
Disconnect the following connectors.
PCM connector E (80P)
A/F sensor (Sensor 1) 6P connector

?4.
Check for continuity between test points 1 and 2.
Test condition
Vehicle OFF (LOCK) mode
 
A/F sensor (Sensor 1) 6P connector: disconnected
 
PCM connector E (80P): disconnected
Test point 1
PCM connector E (80P) No. 73
Test point 2
Body ground

Is there continuity?

     
YES
     
     
     
Repair a short in the VS wire between the PCM (E73) and the A/F sensor (Sensor 1).?
     
NO
     
     
     
Go to step 3.
3.
A/F sensor (Sensor 1) check:

A/F sensor (Sensor 1) check
?1.
Substitute a known-good A/F sensor (Sensor 1).

?2.
Reconnect all connectors.

?3.
Exit the SCS mode with the HDS.


?4.
Turn the vehicle to the ON mode.

?5.
Reset the PCM with the HDS.


?6.
Do the PCM idle learn procedure.

?7.
Check for Pending or Confirmed DTCs with the HDS.
DTC Description
Confirmed DTC
Pending DTC
P2252 A/F Sensor (Sensor 1) VS Circuit Low Voltage
    

Is DTC P2252 indicated?

     
YES
     
     
     
Check for any authorized service information related to the DTCs or symptoms you are troubleshooting, or substitute a known-good PCM.?
     
NO