DTC Troubleshooting: P0069 (2.4 L Engine) - Honda CR-V RW/RT 2017-2020

DTC Troubleshooting: P0069

DTC P0069: BARO Sensor Circuit Range/Performance Problem

NOTE: Before you troubleshoot, review the general troubleshooting information.

DTC Description	Confirmed DTC	Pending DTC
P0069 BARO Sensor Circuit Range/Performance Problem

Problem verification:

Problem verification

?1.	Turn the vehicle to the ON mode.

?2.	Clear the DTC with the HDS.

?3.	Start the engine.

?4.	Hold the engine speed at 3,000 rpm without load (in P or N) until the radiator fan comes on, then let it idle.

?5.

Test-drive the vehicle under these conditions:

	Engine speed above 1,000 rpm and REL TP SENSOR above 12 deg (or engine speed above 3,000 rpm and REL TP SENSOR above 25 deg)
	Drive 2.5 seconds or more

Signal	Current conditions
Signal	Values	Unit
ECT Sensor 1
Engine Speed
REL TP Sensor

?6.

Check for Pending or Confirmed DTCs with the HDS.

DTC Description	Confirmed DTC	Pending DTC
P0069 BARO Sensor Circuit Range/Performance Problem

Is DTC P0069 indicated?


	YES

The failure is duplicated. Check for any authorized service information related to the DTCs or symptoms you are troubleshooting, or substitute a known-good PCM.?


	NO

Intermittent failure, the system is OK at this time. If the on-board snapshot of this DTC is recorded, try to reproduce the failure under the same conditions with the on-board snapshot.?