C1C04-11 Brake Pedal Stroke Sensor Power Circuit Short To Ground or Battery
1.
Problem verification:
Problem verification
?1.
Turn the vehicle to the ON mode.
?2.
Clear the DTC with the HDS.
?3.
Turn the vehicle to the OFF (LOCK) mode, then wait 5 seconds or more.
NOTE: Do not open and close the driver's door.
?4.
Turn the vehicle to the ON mode.
?5.
Check for DTCs with the HDS.
DTC Description
DTC
Freeze Frame
C1C04-11 Brake Pedal Stroke Sensor Power Circuit Short To Ground or Battery
Is DTC C1C04-11 indicated?
YES
The failure is duplicated. Go to step 2.
NO
Intermittent failure, the system is OK at this time. Refer to intermittent failures troubleshooting. If the freeze data/on-board snapshot of this DTC is recorded, try to reproduce the failure under the same conditions with the freeze data/on-board snapshot.?
2.
Shorted wire check (PTS VS line to +B EBB line):
Shorted wire check (PTS VS line to +B EBB line)
?1.
Turn the vehicle to the OFF (LOCK) mode with driver's door open.
Repair a short in the wire between the electric brake booster and the brake pedal stroke sensor.?
NO
Check for loose terminals and poor connections in the electric brake booster 26P connector. Check for any authorized service information related to the DTCs or symptoms you are troubleshooting. If they are OK, replace the electric brake booster.?