Cut the adhesive tape (C) along the edge of the rear door wheel arch protector (D) with a utility knife while separating the trim from the rear door (E) with a trim tool.
NOTE: Apply protective tape around the cutting area.
3.
Slide the rear door wheel arch protector downward and remove it.
NOTE: The clips (F) will stay in the door.
1.
Rear Door Wheel Arch Protector - Install
1.
If you are reusing the original rear door wheel arch protector (A), apply primer to the areas where new double-sided adhesive tapes (B) will be applied, then attach the new double-sided adhesive tapes to the rear door wheel arch protector on the scribes (C) as shown.
Double-sided adhesive tape (B)
Thickness
1.0 mm (0.04 in)
Width
6 mm (0.24 in)
Length
23 mm (0.91 in)
2.
Install the clips (C) on the rear door wheel arch protector (D).
3.
Hold the rear door wheel arch protector up, and fit all the clips into the holes in the rear door. Push on the panel until the clips snap into place.
