|
DTC Troubleshooting: B1176
DTC B1176: Fuel level sensor (Fuel gauge sending unit) circuit short
|
DTC Description |
DTC |
|
B1176 Fuel level sensor (Fuel gauge sending unit) circuit short |
| |
|
|
1. |
Problem verification:
Problem verification
|
?1. |
Clear the DTCs with the HDS.
|
|
?2. |
Turn the vehicle to the OFF (LOCK) mode and then the ON mode. |
|
?3. |
Wait for at least 30 seconds. |
|
?4. |
Check for DTCs with the HDS.
|
DTC Description |
DTC |
|
B1176 Fuel level sensor (Fuel gauge sending unit) circuit short |
| |
| | |
Is DTC B1176 indicated?
|
|
|
|
|
|
|
Intermittent failure, the system is OK at this time. Check for poor connections or loose terminals.? |
|
2. |
Short wire check (FUEL GAUGE? line):
Short wire check (FUEL GAUGE? line)
|
?1. |
Turn the vehicle to the OFF (LOCK) mode. |
|
?2. |
Disconnect the following connector.
|
Gauge control module connector A (32P)
Fuel tank unit 4P connector | |
| |
|
?3. |
Check for continuity between test points 1 and 2.
|
Test condition |
Vehicle OFF (LOCK) mode
Gauge control module connector A (32P): disconnected
Fuel tank unit 4P connector: disconnected |
|
Test point 1 |
|
|
Test point 2 |
Body ground | |
| | |
Is there continuity?
|
|
|
Repair a short to ground in the wire. |
|
|
|
The FUEL GAUGE? wire is OK. Go to step 3. |
|
3. |
Fuel gauge sending unit check:
Fuel gauge sending unit check
|
Is the unit OK?
|