DTC Troubleshooting: B1647
DTC B1647: Passenger's Door LF Antenna Circuit Short
DTC Description |
DTC |
B1647 Passenger's Door LF Antenna Circuit Short |
| |
|
1. |
Problem verification:
Problem verification
?1. |
Clear the DTCs with the HDS.
|
?2. |
Select the KEYLESS ACCESS CONTROL UNIT from the ONE-PUSH START system select menu with the HDS, and enter the SELF CHECK.
|
?4. |
Check for DTCs with the HDS.
DTC Description |
DTC |
B1647 Passenger's Door LF Antenna Circuit Short |
| |
| | |
Is DTC B1647 indicated?
|
|
|
|
|
|
|
Intermittent failure, the system is OK at this time. Check for loose or poor connections.? |
2. |
Shorted wire check (EXT FR AS?, EXT FR AS? lines):
Shorted wire check (EXT FR AS?, EXT FR AS? lines)
?1. |
Turn the vehicle to the OFF (LOCK) mode. |
?2. |
Disconnect the following connectors.
Body control module connector F (36P) |
Front passenger's door outer handle 8P connector | |
| |
?3. |
Check for continuity between test points 1 and 2.
Test condition |
Vehicle OFF (LOCK) mode Body control module connector F (36P): disconnected Front passenger's door outer handle 8P connector: disconnected |
Test point 1 |
|
Test point 2 |
Body ground | |
|
Test point 1 |
|
Test point 2 |
Body ground | |
| | |
Is there continuity?
|
|
|
Repair a short to ground in the wire.? |
|
|
|
The EXT FR AS? and EXT FR AS? wires are not shorted. Go to step 3. |
3. |
Shorted wire check (EXT FR AS? line to EXT FR AS? line):
Shorted wire check (EXT FR AS? line to EXT FR AS? line)
?1. |
Check for continuity between test points 1 and 2.
Test condition |
Vehicle OFF (LOCK) mode Body control module connector F (36P): disconnected Front passenger's door outer handle 8P connector: disconnected |
Test point 1 |
|
Test point 2 |
| |
| | |
Is there continuity?
|
|
|
Repair a short in EXT FR AS? wire to EXT FR AS? wire.? |
|
|
|
The EXT FR AS? and EXT FR AS? wires are OK. Go to step 4. |
4. |
Body control module EXT FR AS?, EXT FR AS? line output check:
Body control module EXT FR AS?, EXT FR AS? line output check
?1. |
Reconnect the following connector.
Body control module connector F (36P) | |
| |
?2. |
Turn the vehicle to the ON mode. |
?3. |
Measure the voltage between test points 1 and 2.
Test condition |
Vehicle ON mode Front passenger's door outer handle 8P connector: disconnected |
Test point 1 |
Front passenger's door outer handle 8P connector (female terminals) No. 2:  |
Test point 2 |
Front passenger's door outer handle 8P connector (female terminals) No. 6:  | |
|
| |
Is there voltage?
|